Замена переднего сальника коленвала на шевроле нива без кондиционера

Замена переднего сальника коленвала на Шевроле Нива без кондиционера

The front crankshaft oil seal on a Chevrolet Niva is responsible for preventing oil leaks and ensuring the smooth operation of the engine. If you notice a significant oil leak coming from the front of your Niva’s engine, it may be time to replace the front crankshaft oil seal.

Replacing the front crankshaft oil seal on a Chevrolet Niva without air conditioning is a relatively simple and straightforward process that can be completed with some basic tools and mechanical know-how. Here is a step-by-step guide to help you replace the front crankshaft oil seal on your Niva.

Step 1: Disconnect the Battery

Before starting any engine-related repair work, it is important to disconnect the battery to prevent any electrical hazards.

Step 2: Remove the Alternator Belt

The next step is to remove the alternator belt. Loosen the bolts that hold the alternator in place, and then push the alternator toward the engine to loosen the belt. Once the belt is loose, remove it.

Step 3: Remove the Crankshaft Pulley

The crankshaft pulley is held in place by bolts that need to be removed. After the bolts have been removed, use a pulley puller to remove the pulley from the crankshaft.

Step 4: Remove the Timing Belt Cover

The timing belt cover is held in place by several bolts. It is important to remove all of the bolts and gently pry the cover off to avoid damaging the gasket.

Step 5: Remove the Timing Belt Tensioner

The timing belt tensioner needs to be loosened and removed to gain access to the front crankshaft oil seal. After removing the tensioner, slide the timing belt off the crankshaft pulley.

Step 6: Remove the Front Crankshaft Oil Seal

Using a flat-head screwdriver or a seal removal tool, gently pry the old front crankshaft oil seal out of its housing. Be careful not to damage the housing or the surface where the new seal will be installed.

Step 7: Install the New Front Crankshaft Oil Seal

Before installing the new front crankshaft oil seal, apply a small amount of engine oil to the inner lip of the seal. Install the new seal by using a seal driver tool or a socket that is the same size as the outer diameter of the seal. Gently tap the seal into place with a mallet until it is flush with the housing.

Step 8: Reassemble the Engine Components

Reassembly is the reverse of the disassembly process. Start by reinstalling the timing belt tensioner and the timing belt. Once the belt is in place, reinstall the timing belt cover, the crankshaft pulley, and the alternator belt. Finally, reconnect the battery.

Replacing the front crankshaft oil seal on a Chevrolet Niva without air conditioning is an easy and straightforward task that can be completed with basic tools and some mechanical knowledge. By following these simple steps, you can prevent oil leaks and ensure the smooth operation of your engine. If you are unsure about any of the steps involved in this process, it is always best to consult a professional mechanic for assistance.